NEWS CENTER

The internal structure of the new carbonization furnace;

The new retort carbonization furnace adopts a horizontal method, which makes loading and unloading the furnace very convenient. Because the new carbonization furnace consists of an inner tank, insulation layer, furnace door, rail car, combustible gas backburner pipe, dehumidification buffer tank, burner, exhaust pipe, thermometer, etc. The flue gas purification device and vaporizer can be configured separately. Various materials can be carbonized and processed.

There are four steps in total: feeding and sealing the furnace → preheating and drying → anaerobic carbonization → cooling to produce charcoal.

New retort carbonization furnace carbonization workflow;

1; Feeding materials and sealing the furnace: Use a rail car to feed the raw materials into the carbonization furnace, lock the furnace door, and finally seal the furnace.

2. Preheating and drying raw materials: Use wood or other fuel to heat the raw materials in the furnace, and slowly raise the temperature from room temperature to 220-250°C. This process takes 4-6 hours. The specific time depends on the dryness and wetness of the wood and mainly depends on the moisture content, density, diameter, etc. of the raw materials.

3. Anaerobic carbonization: When the temperature in the carbonization furnace rises to the point where a small amount of yellow smoke (hydrogen, oxygen and other volatile substances) is discharged from the smoke pipe, the carbonization process begins. At this time, the combustible flue gas can be recovered and put into the furnace for ignition and adjustment. The amount of combustible smoke inhaled should be kept at around 300-550℃ for 2.0-3.5 hours. After the natural combustion in the furnace stops, the carbonization ends.

4; Cooling and carbon removal: After carbonization is completed, the cooling water valve needs to be opened to cool the inner tank. When the temperature of the inner tank drops below 50°C, the furnace door can be opened to remove carbon.

The exhaust gas of the new carbonization furnace is discharged through the dust collector, which meets environmental protection requirements. It can maximize the use of combustible flue gas to heat the carbonization furnace and reduce fuel consumption.

• Prev：What is the process principle of can paint stripping treatment equipment?
• Next：Operating steps and internal structure of suspended carbonization furnace